Akademik Veri Yönetim Sistemi
STRAIN, cilt.59, sa.5, ss.1-18, 2023 (SCI-Expanded)
The main aim of this work is to comparatively reveal the effect of fibre type, length and content on compressive strength and microstructure of structural geopolymer concrete (GPC) produced under constant mixture and curing parameters in order to address the significant gap in present literature. Firstly, GPCs with different NaOH concentrations (i.e., 6, 9, 12 and 15 M) and activator solution/binder (a/b) ratios (i.e., 0.45 and 0.55) were produced in ambient curing condition, and optimum production parameters were determined based on the preliminary evaluations. Then, glass and polypropylene fibres in 6-mm length (GS6 and PP6) and polyamide and polypropylene fibres in 12-mm length (PY12 and PP12) were included in GPCs at ratio of 0.4%, 0.8% and 1.2% (by volume). Compressive strength, apparent porosity, bulk density, ultrasonic pulse velocity (UPV), X-ray diffraction (XRD) and scanning electron microscope (SEM) analysis of GPC samples were carried out comparatively. The inclusion of GS6 fibre enhanced the compressive strength thanks to fibre surface being covered by geopolymer gel and the strong adhesion between GS fibre and geopolymer matrix. SEM images of fibre reinforced GPC (FRGPC) also confirmed the experimental findings, which were attributed to improvement in compressive strength. Regardless of the fibre type, the maximum compressive value strength was obtained from GPC specimens with 0.4% fibre and then decreased. Higher fibre inclusions led to poor compaction, workability issues and inhomogeneous fibre dispersions. A very good relation (R2 = 0.98) was acquired between UPV and compressive strength values of GPC/FRGPC samples.